Voltage: *12 Volts
Output: *AC (External Rectifier) DC (Internal Rectifier)
Number Of Blades: *3 Blades 5 Blades 7 Blades
Blade Color: *Gray Black
Add Marine Varnish
What you get with the 500 Watt Wind Turbine:
3, 5, or 7 Raptor Generation 4 Wind Turbine Blades for maximum output
Assembled blades are 60" diameter
Blades do not overload the PMA at low RPMs, turns faster for more amps
Wind Turbine Blade Hub
3/16'' thick steel, no cheap aluminum or plastic
Zinc Plated or Powder Coated
500 Watt Permanent Magnet Alternator
Standard 17 mm shaft
100% solid core zinc plated rotor design with air flow holes for cooler operation
Smoother operation with flywheel power boost
Housing bolts treated with anti-seize to prevent dissimilar metal corrosion
Above 500 watts if you have zone 2 winds or above; power rated when using Raptor G4 blades. Easy start-up in zone 2 winds or higher depending on blade set.
125,000 hours+ of rated bearing life. New bearings cost only $3.00
AC Output Models: The 3 phase AC to DC bridge rectifier can be installed next to your batteries or inverter for a 3 phase cable run down the tower.
DC Output Models: The 3 phase AC to DC bridge rectifier is built into the case making it a two wire run to your charge controller or batteries.
Tail Fin & Arms
16 gauge powder coated steel
Measures 13 x 19 Inches
Double tail arms
Steel mounting bracket
Fits on 1.5" schedule #40 or #80 pipe
Powder coated
Limited Warranty